Industrial Adhesive & Dosing System Prices and Models
9 products found.
ImageInteg HM-5 Piston Pump Glue Machine
ImageInteg Cartesian Automatic Glue (Silicone) System
ImageInteg Grity-5G Gear Pump
ImageInteg Grity-5 Piston Pump
ImageInteg Grity-10 Piston Pump
ImageInteg Grity-20G Gear Pump
ImageInteg Grity-20 Piston Pump
ImageInteg Grity-5G Gear Pump
ImageInteg Grity-10G Gear Pump
Industrial Adhesive & Dosing Systems: Hot Melt, Two-Component Dosing and Dispensing Robots
The Industrial Adhesive & Dosing Systems category covers systems that melt, mix, meter and precisely apply adhesives, sealants, silicones, epoxies and polyurethanes on the production line. Case and carton sealing, furniture and edge bonding, automotive part assembly, electronic board protection, filters and hygiene products are their most common applications. On makinateklif.com you can compare new and used adhesive and dosing system listings by system type, material, capacity and location.
Types of Adhesive and Dosing Systems and What Each Is For
Hot melt units: Melt thermoplastic adhesive and apply it with guns or nozzles; the most common system on packaging lines.
PUR reactive adhesive systems: For furniture, automotive and textile applications needing moisture and heat resistant bonds.
Cold glue systems: Apply water-based adhesives to paper, board and wood with pumps and guns.
Two-component (2K) meter mix machines: Mix epoxy, polyurethane and silicone at the correct ratio and dispense them.
Benchtop dispensing robots: Deposit precise amounts of material along programmed paths on small parts.
Spray adhesive and coating systems: Apply thin, even layers over large surfaces.
What Determines Adhesive and Dosing System Prices?
Material type: Hot melt, PUR, water-based adhesive or two-component resin.
Tank and pump capacity: Hourly melt and application rate.
Number of guns and nozzles: How many points can be applied at once.
Dosing accuracy and control: Ratio control, flow sensors and programmable application.
Integration: Working with robots, conveyors and the line PLC.
What to Check When Buying a Used Adhesive and Dosing System
New and used machines from manufacturers such as Nordson, Graco and Robatech are widely traded. When assessing a used machine, it is worth checking the following:
Melt tank, heated hoses and guns hold temperature correctly
No clogging, leaks or wear in pumps, valves and nozzles
Mix ratio and mixer work correctly on two-component systems
Control unit, sensors and automation connections work properly
A trial application with your own material and part
New systems with service support are chosen for high-speed packaging and assembly lines, while well-maintained used systems suit spares and low-volume work.
